|
Foamtech
Back to Expansion Joints
Are you tired of:

IS THE ANSWER!!
Foamtech®
is a closed cell, non-crosslinked polyethylene foam, available in black or white, and can be used in all standard concrete
construction applications. It is widely used in residential, commercial and industrial construction.
Features:
- Foamtech® - Extruded from high quality polyethylene
foam by the world's foremost leader in polyethylene and packaging products
- Peel off Strip - Standard
on each roll, but can be special ordered without
- Flexibility - Will not
break or crack when used around curves or columns
- Lightweight - Approximately
10 times lighter than traditional expansion joint products
- Accepted - Commonly
used by both commercial and residential contractors
- Durable - With near
zero water absorption, Foamtech® will
not rot out of the joint over time
- Economical - Easily
cut and handled on any jobsite
Installation:
- Your setup is all the same, no special equipment is required.
- Simply install Foamtech® with the peel strip either up or down, depending on if the joint will be sealed
or not
- Install using spray on adhesive, mechanical fastners, or depending on the surface
simply smack it with a hammer.
- Finish the concrete as you normally would
- If the joint will not be sealed then you're done, if it will be sealed,
utilize the peel top feature to create the sealant cavity.
|